Speak to an expert

What is a Room Oxygen Monitor and how do you know if you need one?

As you will know oxygen is essential for respiration, the normal level of oxygen in the air that we breath is 20.9 percent, but did you know that the levels of oxygen don't have to drop much to have an adverse effect on a person.

At an oxygen concentration of 19 percent some physiological effects will start to occur; however, these won't always be noticeable. Between 15 and 19 percent thinking will become impaired, along with coordination. A reduction in intellectual performance ensues typically without awareness, just when you potentially need to make life saving decisions. At 12-15 percent you will experience poor judgement and abnormal fatigue; this will increase as the levels drop to 10-12 percent, and there is a distinct possibility of fainting within just a few minutes. If levels drop below 10 percent a typical person will experience an inability to move, loss of consciousness and convulsions followed by death in as little as nine minutes.

So, what situations can cause an oxygen depleted atmosphere? Oxygen deficiency normally occurs in an enclosed space and can be caused for a variety of reasons. Where there is a volume of gas, be that in a tank or pipeline, leaks can quickly fill an enclosed space displacing the oxygen. Another cause is decomposition of organic matter, plant or waste material for instance emit carbon monoxide, carbon dioxide and potentially hydrogen sulphide, these displace the oxygen and, in some cases, react with the oxygen resulting in an oxygen deficient environment.

According to the Health and Safety Executive (HSE) a confined space is defined as: A place which is substantially enclosed (though not always entirely) and where serious injury can occur from hazardous substances or conditions within the space or nearby (e.g. lack of oxygen).

As such, you would be excused for thinking that a laboratory or room wouldn't require an oxygen monitor. However, there are scenarios where a room oxygen monitor would be required - if you consider a cryogenic lab for instance, many litres of liquid nitrogen are stored within the freezers. Given that liquid nitrogen expands by 694 times upon evaporation, it's easy to see how a leak could quickly displace the oxygen within a room rendering it deadly. In fact, the Occupational Health and Safety Administration (OSHA) regulations require that any room where compressed gases are used or stored are fitted with oxygen deficiency monitors.

Monitors, when properly functioning, should measure the oxygen concentration within the room and alarm if it should dip below 19.5 percent. Therefore, remembering that every gas detector is only as good as its last calibration, it is important to regularly function test and calibrate at the prescribed interval period. A quality calibration gas is never far away, Air Products offers lightweight canisters of all common calibration gases on their online store ready for immediate despatch: airproducts.expert/uk/oneuse

 

Air Products white lines

Testimonials

"Our business relies on simple bump testing of gas detectorson board marine vessels. Complex high pressure cylinders and regulators would make the job too difficult but we find the Air Products non-refillable offerings very easy to use and the equipment is simple to operate."

GMS Instruments, Rotterdam

"We are involved in the installation, commissioning and maintenance of a wide range of gas detection equipment into many market sectors. The fact that the Air Products’ range covers all of the flammable, toxic, quad-gas and corrosive gas requirements for this market is very important to us."

Autochim, France

"Personal, portable and fixed gas detection equipment is widely used in many safety critical applications and these items are often subjected to relatively harsh environments and working conditions. The gas sensing element within this equipment is perhaps the most fragile and crucial component, and if this was to fail, it would render the equipment useless. The selection of appropriate test gas is important to ensure the bump test is carried out correctly and as an active member of CoGDEM, Air Products know about it. They have contributed to the CoGDEM Guide to Gas Detection, a new hardback reference book which explains best practice and aids the selection of suitable test gases and equipment."

Leigh Greenham, Director, CoGDEM